Jump to content

Lava Rock

Members
  • Posts

    11,875
  • Joined

  • Last visited

Everything posted by Lava Rock

  1. we have production run tomorrow in pwm. I told the guys we're going to lose power and that'll likely mean we have to discard the run/product. We're in such backlog we can't afford not to manufacture, but we also face the likelihood of dumping the material if power goes out. can't win
  2. pick your poison I guess. 16" of hvy sn or 12" sn with 4" IP. Gonna be a bitch to remove either way. I intend to snowblow early in the a.m., again tomorrow night, then again fri morning if needed
  3. Jfc. Don't want it. Nuts Sent from my SM-G981U1 using Tapatalk
  4. Good. Let's widdle this down to less than 10". I hope is busts badly Sent from my SM-G981U1 using Tapatalk
  5. I've got a honda genny. I usually wheel it out then put a folding table over it then a tarp. I leave the ends open. Poor mans shelter but I only do this in bad rain or sn storms. Does everyone else cover their portable genny or do leave it uncovered and hope for the best
  6. But what about the EVs? Poor souls Sent from my SM-G981U1 using Tapatalk
  7. the red flashing piece as you've depicted is not present. The dripping as of yesterday has stopped, despite the residual snow melt, so I think the ice dam from last week's storm allowed for water pooling in the soffit, but I need to better identify, using a roofer, potential issues. thanks
  8. I have pics from when house was built, but none unfortunately that shows the ice shield installed.
  9. there's definitely drip edge and it juts out enough so that the water runs directly into the gutter. I think you're right about not enough ice shield due to the buckled shingles. I think the water was pooling in the soffit. When I took a level to the pine soffit pieces, some of them slope towards the house just enough so that water would eventually drip down the siding. No evidence of wall wetness or damage inside. We also have 1/2" foam board behind the siding so I believe the water is leaking between this foam surface and the backside of siding, but hopefully not on the backside of foam and OSB. I need to a roofer to take a look.
  10. Looks more reasonable. Carson pumping 12-18 Sent from my SM-G981U1 using Tapatalk
  11. We had an ice dam awhile ago and it all melted last week yet I'm still getting water driping down siding and at the corner of the valley where the gutter is. I thought the melting snow was dripping behind the gutter but it's not. The soffit must be full of water, otherwise not sure where it's coming from. Sent from my SM-G981U1 using Tapatalk
  12. Lol, I figured. Just don't want anymore sn Sent from my SM-G981U1 using Tapatalk
  13. Mondays good Sent from my SM-G981U1 using Tapatalk
  14. What are the chances we get nothing as in no sn or rn Sent from my SM-G981U1 using Tapatalk
  15. Thanks kev Sent from my SM-G981U1 using Tapatalk
  16. I don't. I'm pissed we surpassed what I thought was going to be our lowest total since 2009 Sent from my SM-G981U1 using Tapatalk
  17. is this what your buds on r/conspiracy are saying? I like to read stuff there, but this isn't what happened
  18. Wow, this isn't good. Baltimore bridge collapses after tanker hits it https://twitter.com/MarioNawfal/status/1772524860985491595/mediaViewer?currentTweet=1772524860985491595&currentTweetUser=MarioNawfal Sent from my SM-G981U1 using Tapatalk
  19. 10.75". Pretty difficult to snowblow Sent from my SM-G981U1 using Tapatalk
  20. Lol, I was just looking at the cams and was a bit skeptical Sent from my SM-G981U1 using Tapatalk
  21. Don't forget to shovel Sent from my SM-G981U1 using Tapatalk
  22. 7.5" of useless sludge. IP now. 27F Sent from my SM-G981U1 using Tapatalk
  23. Same here. 6" Sent from my SM-G981U1 using Tapatalk
×
×
  • Create New...